47014 Punch PUN: Punch Motor <MotorID - The punch motor that has drawn execssive current> has exceeded hardware current threshold Activated punch motors are expected to complete their punch cycles using less than a nominal maximum current. If this current is exceeded on any punch cycle, the punch will automatically return to the home position and make another attempt at completion. If the punch cycle can not be completed after four attempts without the motor drawing excessive current, the activation command fails with this error. This error could occur during either initialization or a normal punch cycle. There are two 'excessive current thresholds' in the punch system, one defined by hardware and one defined by firmware. This error occurs when the hardware threshold is exceeded. This error could occur during either initialization or a normal punch cycle. The firmware over current threshold is lower than the hardware threshold but is slower acting since it is based on a filtered analog value. The hardware over current threshold is higher but faster acting since it is based on a single occurrence of a detected instantaneous peak current. This error is reported. punch motor coil or connecting cable is shorted MotorID - The punch motor that has drawn execssive current. 07-Jun-2006 ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:51 2008 PST